I want to mirror Sketch15 to opposite side but in the entity to mirror box it is not coming. What is the reason? If I select the curves individually it is coming.
I think I understand what you are getting at Maha. The sketch mirror does not mirror the sketch itself but entities within the sketch. From your screenshot above either use the selection tools (such as box select or lasso) or do a Ctrl+A then select the mirror about line. This was done with a Ctrl+A.
Do you have Box Select turned on?
How to differentiate whether Box Select is turned on or off? because it looks same whether it is turned on or off.
(Ctrl+A) gives result but "Box Selection or Lasso Selection" does not give any result.
Hmmm,,, You do realize you actually have to drag the cursor to encompass the entities you want to select?
Thanks for the help.
Are these sketches different in nature?
Original sketch, Convert Entity Sketch & Offset Entity Sketch
You certainly have an inquisitive mind and no doubt that is going to work in your favor. With a little thought into this question the first things that come to mind are that an "original sketch" needs to have relations added in order to become fully defined. A sketch that is converted automatically has an on edge relation and because of that it is fully defined. An offset sketch has an offset dimension added automatically fully defining it if the original sketch is defined or if it is offset edges then it would be automatically defined regardless. Both Convert and Offset are dependent on some other geometry. Someone else may have a better explanation than mine but these are the first things that come to mind.
Normally I made selection from FM tree but in this case it is different that is why I want to know.
Retrieving data ...