SW 2017 irregularly creates transfer on a surface... рукожопс... Bends a contour with shift and turn
Shon.... yeah, sadly.. even if you set this on "High"... this new functionality is not very good.... .we'll have to wait for a "new and improved" version... ???
...and just to remeber,... the old option (analytical, below)... and the new option (spline... or the above,.. the one you chose)
Hey Paul,,, Looks like if you do "Analytical" it works out pretty good..
Yes!... just updated my post to include the two options...
I do think the "spline" option should be more accurate with this revolved geometry though.. that is, as is... there are assumptions built in to this new spline map.. so.. .. we need XY and rotating options to better control this map/projection... it should be included with this feature, imho.
..like,.. UV mapping... since this is like applying a decal/label/cloth.
Yes,, strangely if you turn this into a solid and go for an emboss or deboss you do get an option for pull direction. Seems like you should have that option regardless..???
DING-DING-DING...!!! You win the Friday Virtual Beer!!!!
For this case of a rectangle - Split will be suitable. BUT!!!!! How it is possible to trust transfer for other contours and sketches if it lies at transfer of a routine rectangle?
Split line did the job. However it put it on both sides (since it is one surface) Delete and patch face will get rid of one.
Guess I misunderstood the question.
You understood nothing from my example!!!!! read my previous message attentively!!!!
It is impossible to trust this function if she is mistaken on trifles! You счас though understood that?
Whether also you will trust if the projected sketch is not a rectangle? And for example curve? but with transfer on this surface. Split will not help you with it too!!!
In my opinion I have enough experience to tell where in SW made through an ass and where is not present.
In this subject only the programmer a hand - asses which through an ass wrote function of transfer of the sketch on a surface will be able to answer - it is my opinion. and the Others can just wait for SP of correction of its mistake!
Why do I feel offended by this??
Dave,.. I hear ya, but I can imagine Shon was frustrated and the translation maybe a bit non specific.. ?
I sure the hell hope so. It's like with most issues in SW, there are many ways of accomplishing most problems. I offered up one.
If you trust SW, than you are work with some function. If you sow mistake.... how to work with this bug (if the routine rectangle develops irregularly)?
Shon,.. I would not expect anything accurate from the new spline wrap.... period.
or,.. not until this new spline wrap feature has information and tools explaining relative accuracy to the sketch (material?) and surfaces it is mapping over...?
.. if the user has these tools and information.. it would better help reassure the sketch (or material which is being applied) is within a range or mapping accuracy/deviation per the sketch (label/cloth/transfer,..) and surfaces it interpolates over?
Retrieving data ...