AnsweredAssumed Answered

link balloons and cut lists to sub-assembly only

Question asked by Shane Kozlowski on Apr 27, 2017
Latest reply on Apr 28, 2017 by Andreas Rhomberg

     I would like to add a weldment cut list and balloons to this assembly section view but I only want the cut list from the darkened weldment part, not the entire assembly.

     This part is built in place on the almost finished assembly and measurements depend on certain conditions of the parts already in place, which vary depending on specific customer needs. So, drawing it without the rest of the assembly will not be very helpful to the building process because it cannot be accurately printed to be built outside the unit and put in place.

     Is there a way I can link to the weldment cut list of that specific part within the assembly and also balloon to that part?