I am working with a hole feature and have gotten this error message when changing the end condition from "BLIND" to "UP TO NEXT":
"The end face cannot terminate the extruded feature"?
What the heck?
I am working with a hole feature and have gotten this error message when changing the end condition from "BLIND" to "UP TO NEXT":
"The end face cannot terminate the extruded feature"?
What the heck?
Wait... I figured it out.
The hole feature on the back of the part was set to "blind" as well and it created a drill point where my other hole was trying to end.
I set that hole to "up to next" and voila! everything works.