2 Replies Latest reply on Aug 29, 2017 7:48 PM by Adam Hartles

Sub assembly parts suppress in large assembly.

Daniel Baker Apr 19, 2017 9:07 AM

I have a large assembly and when I open it certain sub assemblies have some, but not all, of their parts suppressed.

When these sub assemblies are opened from within the parent assembly they have the parts suppressed and un-suppressing them does nothing.

However if these sub assemblies are opened first, all parts load fine within the sub assembly. Then if the main assembly is opened all parts are shown.

Has anyone experienced this before ?

Re: Sub assembly parts suppress in large assembly.

Yves Garin Aug 29, 2017 9:22 AM (in response to Daniel Baker)

Hi Daniel,
I had the same issue when opening large step files, all the parts were suppressed and I had to unsupress manually.
I've just found the answer :

Open System Options - Assemblies and uncheck the Opening large assemblies Use large assembly ... (the one in light blue on the picture).

Yves
Like Show 1 Likes(1)

Actions
Re: Sub assembly parts suppress in large assembly.

Adam Hartles Aug 29, 2017 7:48 PM (in response to Daniel Baker)

Daniel

check your dismissed messages in System options messages/errors/warnings. There may be one related to an "Internal ID..." conflict. Reinstate dismissed messages and try opening the assy again.
Like Show 1 Likes(1)

Actions

Go to original post