I am doing flow simulations in solid works 2016 simulations. For the flow simulation I have tried time and time again and have had the same output.
I need to submit it for a competition. I need the help please.
The behavior you are describing sounds like the body could be a surface rather than a solid. Flow Simulation does not recognize surface geometry when calculating flows so any surface body would just be ignored in the flow field.
Is your model a surface? Are you able to upload it to this thread?
It is a surface
Is there a way to convert a surface to a solid
Perhaps the easiest way to convert it to a solid would be 'Insert', 'Boss/Base', 'Thicken' to apply a small thickness to the surface. It would then be solid and seen in Flow Simulation.
Retrieving data ...