Im making a drawing for fabrication, so i try to use auto ballon in the first sheet and it good but after adding another sheet and use it the problem came out, This is assembly not a part.
Make sure that BOM/Cut list this view refers to is the same configuration as this view.
Hi thanks Deepak Gupta is this what you mean?, because when i check the box and point the right bill of materials the balloon numbers show up. I have never done this for the previous SW version since the balloon number shows up matching the bill of materials.
Does your model has multiple configurations? If yes then make sure BOM is from same configuration.
Also check and make sure that body is not set to exclude from BOM.
Ok thanks it solve my issue, im not a fun of using configuration but sometimes i need to use it, thanks again
Retrieving data ...