I have a plate with several holes in it that were added using the new advanced hole tool. However, when I try to add them to a hole table on a drawing, I get the message shown below:
Does this mean I have to go back to using the old method of using library features to create advanced holes and combining the annotations into a note? Ultimately, this feature is useless if you can't dimension it on the drawing. I mean it doesn't even let me insert a traditional hole callout.
When advanced hole was in beta, there was a way to call out the hole. Since the hole table is not used much where I work, I never checked that out. I am hoping SW2018 will fix these issues (but don't hold your breath). So yes the feature is pretty much useless in my opinion.