Fill Surface does not work says please select the edges after I have picked the edges boundry surface does not work either...... And I don't know why I ask questions here no one ever has the answers.........God I hate solidworks!!!!!!!!!!!
I think it's hard to fill that with single surface in SW
You are trying to fill 3 curve edges and a single straight edge to make a close surface
Try adding 2 surfaces as shown
Hope this works
I ended up having to split a lot of it and redo it
..I can guess it's a very/very small overlap or edge/gap which is causing some problem?.
..otherwise, I would probably removed the corner (light blue) and replaced it with lofted/boundary surface.. .then created a fill surface (pink).. (example sldprt attached)
Retrieving data ...