I am trying to recreated the combined hole in the attached file with the new advanced hole tool. However, when I do so, I get the error shown in the image below. Can the advanced hole tool not do this, or am I entering something incorrectly?
You're getting this error because the two elements you are using are not connected to each other. It looks like you have a gap between the near and far side elements. Advanced Hole needs the elements to connect to create a hole so if you change the far side element to Up To Next Element (note this is a new end condition and is not Up To Next) the straight hole would automatically connect itself with the Near Side Counterbore you have.
Check out the Help for more information.
Hope this help,
I was able to use your part & add an Advanced hole, although I had to delete existing holes & start from scratch on Advanced Hole for some reason. Take a look at this video & see if it helps.
Ah! Thanks! I did not realize that the counterbore feature did not include the clearance hole for the screw itself. When I think about it, this makes sense, and looking at the way the icon looks in the menu (with the dotted line for the hole), I see I should not have expected it to have been included.
Retrieving data ...