AnsweredAssumed Answered

copying text in a sketch

Question asked by 1-FMY2FS on Dec 5, 2008
Latest reply on Dec 8, 2008 by Kevin Drew
hello - a "newbie" question here again - sorry if this has been covered elsewhere -
i am trying to make an embossed scale to add to a machine - i have been able to locate & extrude the first number on the face of the scale but cannot seem to be able to copy the text to a new location to create the next number - the reference geometry will copy but not the text - also i was able to linear pattern the text & skip instances but it would not allow me to change the text after the - it just held the same number - any help or infor would be apprecaited - thank you - am using sw2009