Is it possible to get rid of this line with 2 green dots at the end? Because it is distorting the final loft result.
You can drag the dos around so they line up within the segments. When you do a loft feature, in this case, the point at which you select the curve on both loft sections makes a difference. hat line shows you where you've selected ans can be moved.
those are what control the direction of the laft
Those are indicators - select the center point then it won't distort the model
I tried but I was unable to select the center point, because dot is gravitate towards the corner point of the profile.
Reselect the loft points
That's what they're there for. To maintain the orientation of the loft from profile to profile.
You may also find it useful to use the sketch tool Split Entities on sketch12 so each sketch in your loft has matching numbers of line segments. This would allow for better control of this green dot. Take a look...
Good call. In general, having a 1-1 map for curves and vertices between loft sections will make your life go smoother.
That is the most common reason people have issues with their loft, both sketches - "Must" have the same sketch points, even if it is round to round, round to square or just any crazy sketch, they must all have the same points..
Right-click on the green dot to show more.
Retrieving data ...