AnsweredAssumed Answered

Routed wires are a mess after flatten route

Question asked by Pdm Admin on Mar 3, 2017
Latest reply on Mar 6, 2017 by Pdm Admin

When I use Flatten route after I routed the wires in a 3D model, the flatten route is a mess. Is this a known issue in Solidworks? Or do I something wrong?

I think this wire assembly is little bit difficult, because there a lot of bridge wires in the terminals.
Flatten a 'normal' wire assembly with only wires from A to B, don't give problems.

Attachments

Outcomes