I want to create a cable with two control and wires and two neutral wires and protection. SWE is not allowing me to do it and it says "The phase type "Neutral wire" will be duplicated in the wire style". Is there a way for me to do it?
In Multiple Add wires,each type of wires should be add only once duplication is not possible..You may ADD individual wire..
If you are modeling individual wires running side by side, then the above response applies. However, if you want to model this as an actual CABLE (one sleeved run with multiple conductors inside of it) then it should be possible. To add/manage cables to to your Library tab, go to Cable References Manager, and go ahead and copy or add a new cable. It acts almost exactly like adding a part, you define the baseline properties of the cable, then click the tab to add "cable cores" to define the individual wires running within that cable. Hope that helps!
Retrieving data ...