I am trying to make a full radius along the entire top and bottom surfaces. Please help! Thanks in advance.
updated a little bit
Thanks for the effort but not exactly. I am looking for a FULL radius on the top and bottom not just the edges, so that the top and bottom are fully rounded off if that makes sense.
Ok see attached - I just did the top section for an example..
Yes! But I can't open the file since I am running Solidworks 2015. Was that a boss or cut? I needed material removed not added. Thanks so much!
Then you need to start over using the loft feature, position your existing sketches at the proper levels and use the cut extrude sketch for your guide curve..
Will this work?
you could add a fillet at the very tip of the model if you wanted also R.18
You can fillet both sides till they almost touch to get the effect you want, but if you don't have enough space on the both surfaces then it will fail. Doing a loft with the radius in it like John showed is the better way.
That's about as close as I could ask for. Thanks!
Retrieving data ...