6 Replies Latest reply on Feb 27, 2017 5:27 PM by Dan Pihlaja

    Angular Dimension showing up as linear dimension??

    Sarah Dwight

      I cannot figure out why this dimension is coming up as linear instead of angular?

      The lines are on a second drawing sheet set up as an op sheet and not linked to a model.

      I flipped the .5° angle dimension and now cannot dimension to the centerline accurately.

      The dims show up as linear and have an angled  extension line... instead of just being an angular dimension.

       

      I had to override the dim to show the .50000° in the image below.