1 Reply Latest reply on Feb 23, 2017 11:22 PM by Ryan Dark

    Stick font issues

    Troy Hammons

      I can not make an extruded cut using OLF SimpleSansOC. Any other font works fine. Please advise.

        • Re: Stick font issues
          Ryan Dark

          Hi Troy,
          Stick fonts are composed of both open and closed contours even in single letters.  SolidWorks will not be able to extrude that.  Other fonts are all made of only closed contours which can be extruded.

           

          If you are looking to place this font for and etch other type of engraving operation then you would need to just position the sketch with that text at the intended location and use the sketch for your tool paths.