I have already created a drawing for this part closed and reopened and here we are!
I have come across some issues with Jogs in the past. Do you have the exact error message for Sketch21 / Jog3? Can you upload the file?
Did you make any kind of changes above the Jog after you created the feature? - edit the sheet metal feature and see if the original face is still listed or is it blank?
I personally like the new sheet metal feature ideas - but SolidWorks still needs to work on the One Two to work out all the bugs etc..
I can go back and change my sheet metal feature parameters without causing the part to fail. There are no faces selected in the feature, but the face remains selected in the Jog feature.
I can change them while the session is active. Seems to be hit or miss whether it fails randomly. My work around is to not associate the sketch dims to the model after creation, I reassociate them all to the origin which is not nice (nor the way I like to do things) for design intent.
No changes were made at the time that the errors occur. This occasion I had closed and reopened the top level assembly this was associated with after only having closed SW. It's not every time, it's often though.
My VAR is looking into it as well.
Again no changes were made to the whole, it was essentially just a reopen of SW.
Okay, I understand. At least there is some workaround...though I hope we can find some solution for you on this case.
Retrieving data ...