So essentially I have been struggling with this the past couple of days. I want to wrap a sketch around a wheel. Below is what I am doing to attempt to set it up for just that.
I previously asked this question as an additional question to something I had posted. The answer was that you cannot use "Wrap" with 3D sketches. So my question is why will it only allow me to sketch 3D sketches on the the tangent plane I created? Please don't assume I have any knowledge I am self taught so even the most basic information would do me great good.
Respectfully,
Dustin
Because you're creating the plane while in the 3d sketch mode. Use the plane feature to create the plane first and then do 2d sketch on that and finally use wrap.
You can insert plane via Insert menu OR plane button on the feature toolbar