If you look at the attached image I was wondering if there is a way to control the size of the the virtual sharp witness lines? I would ideally like them to be about half the size they are now. Any help would be appreciated!!
Do not think you can change the size but try using a different style. DOT for e.g.
Thanks Deepak!! After looking everywhere that is the same conclusion I came up with. We recently upgraded from 2012 to 2015. The witness marks were perfect in 2012 but way too big in my opinion in 2015.
Chris, I don't believe any changes were made directly to the length of these lines. Could you perhaps show an example of the differences between SW2012 and SW2015 virtual sharp witness lines? Do the lines change in length if you created in SW2012 then open the drawing in SW2015?
Unfortunately I do not have a way to show you what it was like in SW2012 as I no longer have access to it.
Not sure on 2012 but I do not see any difference between 2013 and 2015
Retrieving data ...