AnsweredAssumed Answered

Static simulation, applying advanced fixtures on imported surfaces.

Question asked by Pim Camps on Feb 20, 2017
Latest reply on Feb 21, 2017 by Gian Flavio Violi

Hallo,

 

I am trying to run a static simulation on automotive body panels, as an imported surface. These panels are measured in real life to check certain displacements. Therefore they are supported in a very specific way with given physical support, only in x,y or z direction. Now im trying to apply an advance fixture in the z direction (up) but only on one specific spot, not the entire area. So my question is; how do I apply a fixture on one specific spot (without making a little hole in the panel whatsoever), not the entire area?

 

Thanks in advance!

Outcomes