Before and during flex I can edit the appearance of my piece as normal but afterwards it is transparent on the outer surfaces.
Can you post it here?
Unfortunately It is not my original design and I can't get ahold of the owner.
Does that happen with every part created with a Flex feature, or just the one part?
It's only on that specific part when I tried on a different part it worked.
You probably have a geometry error that makes SW think your solid is inside-out. Turn on "Verification on rebuild" under Tools->Options, System Options tab, Performance category.
In case anyone wants to see, here's an example bad part created with the Flex feature. It exhibits the inside-out transparency. If you turn on "Verification on rebuild", then Ctl-Q, the Flex feature will error.
Okay I tried that and now the flex feature won't work. So I think you're right. My piece might be too complicated because of some changes done to it. I may have to rebuild it with less steps now that the design is what I want.
Retrieving data ...