AnsweredAssumed Answered

Hey Boss!!! The Plane...... The Plane..... !!!!!!!

Question asked by Dave Bear on Jan 31, 2017
Latest reply on Jan 31, 2017 by Dave Bear

Hi all,

 

As we all know, you can boss extrude in many ways, blind, through all, Up to next, Up To Vertex, Up to surface and so forth. But what I'd like to know is whether or not it is at all possible to extrude up to another plane?

 

I have a model which was created from the front plane (picture attached). I have created another plane that is parallel offset to the front plane by 15 degrees. I would like to extrude some very small features from the front plane (base plate) to the angled plane. Can this be done at all?

 

The picture is a representation only.

 

Dave.

Plane To Plane.jpg

Outcomes