This will probably end up being very simple but I can't seem to find the setting to change this. I can't seem to get my leaders to stop crossing through my dimensions (see the 1.50" in the upper left-hand corner). Can someone please point me in the right direction to fix this?
You might try a different Drafting Standard, but I doubt that will work. It might be an issue with your graphics card (see #13 at Frequently Asked Forum Questions).
Switching to ISO does change it. I had another engineer in the office open the part and they do not have the problem. There must be some setting that I've messed with that is forcing this. Thanks for the response Glenn!
Turning off "display dimension flat to screen" corrects the problem.
One thing to keep in mind is - Anytime you make any changes to the Options, do yourself a huge favor and copy the settings using Copy Settings Wizard and also save your drafting standards as well.....
I have seen that same problem for a while (since I did my last SP upgrade) but never did any searching to find out why (just never got around to it).
I have changed that setting now.
Thanks for the solution.
