I am trying to add a Face Fillet between the 2 split lines and using the 2 Split lines as "Hold Lines". I am not having much luck. with it. Any idea if this can be done?
If you select "Curvature Continuous" as profile, you can use two split lines.
I was able to use hold line if you use your top split line as the edge for hold line. However, I suspect that is not how you want your profile to look like. So I then ran intersection between your model and used cut sweep to kind of get the profile you want, not sure if it is exactly what you need but take a look and see if it can be tweaked for your liking?
I used a spline between the 2 split lines and make it tangent to the vertical and horizontal edges of the bottle. That worked fine.
Happy it worked out for you!
Retrieving data ...