I have a sheet metal part I am forming, and I can't quite figure out a way to close the last gap.
If anyone has suggestions on how I can accomplish this, it would be greatly appreciated.
Message was edited by: Ryan Reynolds
Insert > Sheet Metal > Closed Corner
Might have what you need, but it's kind of hard to tell.
Can you upload what you got??
Oops, should have done that from the start. Sorry.
I would just add a sketch to the preferred surface you choose and extrude it to the same thickness.
For sheet metal designs with odd angles I find it simpler build a Solid Body and convert to sheet metal.
This model also show a 'hybrid modeling' method, using surface to construct solid bodies.
On second thought and being a welder I prefer the half-material overlap, I did this using the Closed Corner tool.
Retrieving data ...