AnsweredAssumed Answered

Sheet metal joggle face "lost" when previous features edited?

Question asked by Gordon Rigg on Jan 13, 2017
Latest reply on Jan 17, 2017 by Gordon Rigg

sheet metal.jpg

The hole in the top of this part is created after the joggle next to it.

when I edit features before the joggle, I find the hole then fails. The position sketch for the hole loses its reference to the surface of the joggled metal, the sketch has missing face- I have to re-select it. (most of the time, but not every edit)

Similarly in the assembly of the part where there is a hank bush in the hole, the mate fails due to missing face (the concentric mate is fine).

I don't recall ever having this problem in previous versions of SW. I am only a few weeks into SW2016. I wondered if anyone else had noticed this issue occurring?

Outcomes