4 Replies Latest reply on Jan 12, 2017 7:17 PM by Andy Cho

    Making a surface flow onto a surface knit

    Andy Cho

      Hi everyone,

       

      I am trying to model a blended wing body aircraft using surfacing tools. When I try to make the landing gear flow from the wing section, I can not make it such that there is a smooth transition from the bottom of the wing to the landing gear. If you look in my model, the landing gear (Boundary-Surface 5) slightly penetrates the rear end of the wing (Surface-Knit 1) section while it does not for the front end.

       

      The end result I'm looking for is for there to be a smooth flow from the bottom of the wing to the landing gear. Any help would be greatly appreciated!

       

      Cheers,

      Andy.