3 Replies Latest reply on Nov 24, 2008 3:25 PM by 1-70W0UV

    Flat Patterns

    Mark Fischer
      Is anyone experiencing issues with sheet metal parts in 2009 sp1.0.

      When we creat a drawing file of a sheet metal part and try to creat the flat blank drawing, SW says it's the flat blank view, but it is not. The part comes in the drawing view not unfolded or Flattened. If you flatten or unfold the part file then the flat blank drawing view changes.

      Whats up with this? We seen 3 or 4 instances of this the past week with sheet metal parts we have drawn.

      Thanks Everyone,