AnsweredAssumed Answered

Clearance ratio

Question asked by Devi Prasad Samal on Nov 22, 2008
Latest reply on Dec 4, 2008 by Derek Bishop

Like • Show 0 Likes0
Comment • 3

Hi,

I am running a frequency analysis, up to meshing all goes well but when i select to run analysis.

there is a tab appear which shows that there is

Warning: Ratio of clearance/element size in at least one element is larger than 1.0

i search the knowledge base but dont get any result?

please help...........

what this means...........

No one else has this question

Outcomes

3 Replies

sandeep pawar Nov 22, 2008 5:16 PM
Mark Correct
Correct Answer
Does that appear only for frequency analysis or for other analyses as well?
Like • Show 0 Likes0
Actions
- Devi Prasad Samal @ sandeep pawar on Nov 27, 2008 4:29 AM
  Mark Correct
  Correct Answer
  I am not tried it in other type of analysis, but it does not happen in static analysis.
  
  it only in frequency analysis..........
  Like • Show 0 Likes0
  Actions
  - Derek Bishop @ Devi Prasad Samal on Dec 4, 2008 10:11 AM
    Mark Correct
    Correct Answer
    I think this relates to the size of the gap between 'contacting' bodies or surfaces. If the gap gets too big, then the software has a problem. Are you meshing with shells?
    Like • Show 0 Likes0
    Actions

Clearance ratio

Outcomes

Related Content

Recommended Content