I'm trying to extrude-cut this circle, but it says "The intended cut does not intersect with the model. Please check the sketch and direction. I tried both directions and it's right in the center so it should intersect.
or if you want to cut thru surfaces, you can use sketch4 to trim the surfaces - see attached model
The lower portion is a surface body - not a solid body.
Your base is surface.
You have 2 options, either make the base a solid and then try cut extrude or create a surface extrude from the same sketch, trim both base and new surface and use knit surface, select "Try to form solid"
Hope this works
Please mark as correct answer so people know when they search
Retrieving data ...