AnsweredAssumed Answered

How to put in a chamfer of different lengths

Question asked by Joshua Erbe on Jan 3, 2017
Latest reply on Jan 4, 2017 by Christian Chu

I'm currently drawing up a diamond scapel blade. Ive attached a pdf of the basic shape. The line sketch on the inside is were chamfer has to meet up to. The cutting edge stays straight. Most of the edges of were the chamfer ends are not parallel with the cutting edge or they do a transition from parallel to about a 3deg angle. My question is, how to I make a chamfer that follows the sketched lines? Ive seen were you can do swepted cuts and such but cant figure out how to make this work.

Attachments

Outcomes