Jeff Cox

Lofted Bend flat pattern

Discussion created by Jeff Cox on Nov 21, 2008
Latest reply on Nov 21, 2008 by Kelvin Lamport
I recently did a rectangular to round transition where the round was not centered on the rectangle (not that that matters). When the shop went to form the parts they decided that they needed more material in the development. I went into the part file and noticed this strangeness: No matter what I do to the K-Factor the flat pattern does not change. I tried changing the thickness of the loft and still no change to the flat pattern. So am I correct in assuming that the lofted bend command is disabled in this regard?

Outcomes