Hi, I've a model with a lot of parts without interference.After the symmetry command I find a lot interference! Why? Thanks, Alex
Hi Alex and welcome to the forum.
A little more information and detail might be needed in this case. Can you attach your part file here? See #18 of Forum Posting on how to do it.
pic1: this is the screen before turning on the mirroring (no interferences as you see in the left side)
pic 2: here i turned on the function mirroring parts and all these interferences appeared on the left side of the screen... what am I doing wrong?
thanks in advanced
What type of interferences are you getting face-to-face (touching) or actual volume interference?
You need to show your planes to see if one is offset from the other, instead of in line...........
What plane did you use for mirroring (symmetry)?
it is volume interference i suppose (the measure is in mm^3) and the plane I'm using is the vertical surface in the base( the one facing the center)
Can you not mirror using one of your origin planes instead Alex? See how that works?
Can you pack and go to a zip file and share it?
Retrieving data ...