AnsweredAssumed Answered

SW2017: Hole call out annotation wizard does not recognize threaded hole on auxiliary view

Question asked by Andrei Ivanov on Dec 23, 2016
Latest reply on Dec 29, 2016 by Solid Air

SW 2017: Part is a cylinder with sets of openings and threaded holes. All openings were defined on work planes. All threaded holes were defined using Hole Wizard.

Hole call outs on left view and view H-H work perfectly. However, on view K-K hall call out recognizes only drill diameter. Same story on view J-J (not shown).

Each view (K-K, H-H, J-J) shows holes in question with cosmetic thread.

 

Has anyone seen similar situation? Any ideas?

Outcomes