Jason Ebersole

Edrawing markup inside assembly file

Discussion created by Jason Ebersole on Nov 20, 2008
Latest reply on Nov 20, 2008 by Wayne Tiffany
I'm an IT guy doing some testing related to PDM, so be nice! Anyway, I discovered that if I open a SW assembly in Edrawing, add a markup comment, and save, it appears as if this info was saved right inside the assembly file. I thought Edrawings would prompt to save the file as an Edrawing file, but it didn't.

So, I then open the assembly in Solidworks, but can't find the markup comments I apparently added with Edrawings. Where did it go?

I'm working with Edrawing2008 & Solidworks2007.

Thanks, Jason