AnsweredAssumed Answered

Lost a Vendor part

Question asked by Dennis Holdgrafer on Dec 15, 2016
Latest reply on Dec 15, 2016 by Rick McDonald

( ? # 1 ) Loaded a solidworks part file (press nut ) from a Vendor and the screen comes in black ( when I had it set to light gray ). I can not see the part at all. I can only see the sketch lines when I mouse over them. Whats up ?  

( ? # 2 ) Was able to load part into an assy ( don't ask how ), part shows up in assy model, when I make the part the displayed part there is a blank screen. The Design tree is populated, mousing over the part and the sketches show up. When I middle mouse button to rotate the part, it shows up, then disappears then I release the button. Any ideas ?

Outcomes