guys whenever i make a part and do tool split it shows error cannot knit surface please help me i have attached part if possible provide with update result thanks in advance
Try to modify the parting line at this location (it should be at the end of the tangent) and see if that help you
When you are in the parting surface, you can try manual mode to fine tune the direction
After I go thru your part, noticed missing shut-off.
You need another internal shut-off to get the core are cavity surfaces proper split
Another issue is the blend radius at most of the split lines, this may cause uneven parting surface.
Is there any reason to select the parting line below the 2 wings (this is a die-lock situation without additional action)
Retrieving data ...