9 Replies Latest reply on Nov 6, 2008 12:40 AM by Jason Aspinall

    Extending surfaces...how?

    Jason Aspinall
      I've got a small ABS design, predominantly a revolved part which needs to have four stabilising legs attached.

      I initially created the legs on the right plane, then offset that plane either side, extracted the sketch then created bodies, then finally suppressed the initial legs. However, as the legs are offset from the centre, none of them are now attached to the main body itself.

      How do I extend the face highlighted in this image:



      so all the legs merge into the main body?