AnsweredAssumed Answered

Can't open Assemblies with cuts in PV360?

Question asked by Daniel Eelman on Nov 5, 2008
Latest reply on Nov 6, 2008 by 1-9C36HC
I wanted to try a section view in 360, but it will not open any assembly files with an assembly cut in them. It immediately throws the error "photoview360.exe has encountered a problem and needs to close", and shuts down. Is this typical behavior? Part files work fine, and the assemblies work fine until I add a cut.

I know I am working with pre-release software here, but just want to see if this is normal at this point. So far, I love 360. In a few minutes I can get a high quality render that I would have struggled with for an hour in photoworks. I am an infrequent user of photoworks, so I have not been able to devote the time to figuring out all the tricks to make it behave the way I would like. I was able to get the attached image out in about 10 minutes with 360.

Attachments

Outcomes