Edit your Profile
Ask a Question
View my Inbox
View trending activity
All Spaces and Groups
About the Forums
Drawing and Detailing
Educators and Students
Hardware and Graphics
Modeling and Assemblies
to create and rate content, and to follow, bookmark, and share content with other members.
Orthotropic material in thermal analyze does'nt work
Discussion created by
on Nov 3, 2008
on Apr 14, 2009 by Brian Wixom
Show 0 Likes
I defined a orthotropic material in a solid thermal analyze.The solid is a cube ,I applied a power in the solid , a convection on one face. But I find wherever the face I apply the convection on,the solution results are the same.
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Apr 14, 2009 5:57 AM
I was able to use the orthotropic material properties. I ran one analysis and it seemed to run fine. Then I ran into trouble with the material database. So, I don't know if it was because of the way I set the orthotropic properties or something completely different.
Show 0 Likes
Retrieving data ...
"Kitty Dump" - SWIFT - "Dumpty Dump"
SWX2020 SP4.0 is Available
Scary Halloween Question: Do you put BOM Tables on your assembly drawings?
How would i create a sketch to make the desired cut in the picture?
Non-technical Thread: Favorite Quotes