for me would be the api real helpful if I could get out the data of the routes, because then I could use these information
to connect it to my database which I used to store all my design data and where I have stored all my relatated data to the P&ID.
I am not interested to generate some geometry, I Should only have access to the data of the routes, because then I have a lot of possibilities
to generate i.e. specific boms, calculate the internal volume of the pipes, painting surface and so on based on my database data.
But acctually I have no way to interlink these data whithout an offical API
Please Please Relase at minimum the Data extraction Interface as soon as possible.
Because I allready rised up this isssue to many of your colleages i.e Eric Leafquist and our german colleage Frank Ruepp
What data is it that you wish to get? For electrical much of the data is accessible, not directly through the API but by reading the xml data that is held inside the assembly.
I am coming up a proposal to link the data of piping to products BOM and then export to database.
Hope API will be at hand when our project kick-off.
Retrieving data ...