AnsweredAssumed Answered

Creation of partial projected view in drawing showing only portion of entire length?

Question asked by Dave Krum on Nov 28, 2016
Latest reply on Dec 1, 2016 by Dave Krum

Good morning All,

Quick question on the possibility of creating a partial projected view?  I didn't see anything pointing to this possibility in help or online so thought I'd throw it out here. Is there a possibility to create a partial projected view of only the right side of the below snip showing just the holes (the rest of bent plate is blank)?  I don't need to show the entire top view as everything besides right end with holes is irrelevant.  I thought maybe a broken out section view but not sure this would work.  Thanks for any input.  On SW2015.

 

Outcomes