AnsweredAssumed Answered

Stiffening Ribs over a irregular closed surface

Question asked by Luca Frondoni on Nov 28, 2016
Latest reply on Nov 28, 2016 by Christian Chu

Hello everyone!

I would like to add stiffening ribs to the component showed below. The surfaces highlighted in blue are where the ribs should go. Closest solution on the web that I could find was this one Stiffening Ribs on Curved Surface , but it didn't really help.

2016-11-28_17-07-00.jpg

 

To help visualize, here is an old component. If possible, I would like for the ribs to follow a cross-type pattern and increase in density as the diameter gets smaller.

 

2016-11-28_17-07-36.jpg

 

Attached both files for reference.

Any help would be greatly appreciated

SW 2016 on Win 10 x64

Outcomes