AnsweredAssumed Answered

Mold Tools - Tool Split

Question asked by Mark Johnson on Nov 16, 2016
Latest reply on Nov 21, 2016 by JOHN GEORGE

Hello.

I have been digging thru the forum for an answer that is applicable but I can't seem to find one.

I have a section in the middle of the part that keeps giving me hard time (or I just don't know it yet). I have two splits done but I don't like either of them. I revised this one with some split lines and I can't get it to do the final split.

I have the parting line done, the shutoff surfaces done (struggle a little bit), parting surface done but when I go to tooling split, I get the PL surface must be larger error.

Can you please take a look at this and tell me what I should have done better??

Thanks very much for your help

Outcomes