AnsweredAssumed Answered

Transferring Custom Properties from inserted part

Question asked by Rob Edwards on Nov 8, 2016
Latest reply on Nov 8, 2016 by John Stoltzfus

Hi All

 

I wasn't quite sure where to ask this question, it's seem's to have been covered in the past but I couldn't find a solution,, other than this terse yet sanguine note in what's new in 2013

I'm just learning to use properties so it's 'all' a bit confusing at the moment.  Im on SW15SP4.

 

  • Here's my example properties, this seems to work fine

 

  • When I insert the part and transfer custom properties, the configurations don't match

 

 

  • The properties are available in the flyout menu

...but they cause a syntax error if you try and use them

  • and they dont 'stick'

 

Learning SW seems to be like navigating a labyrinth :/

Outcomes