I am trying to fill in the two three-sided gaps in this part with the lofted boss/base feature, but the gap is either not being filled completely, or is giving me error messages. How else should I go about this?
You could create 2 curves (either 3D sketch or composite curve) and make a loft surface as shown
Hope this works
Boundary is a way to go. I replace the the end constraint from" tangent to face" to "curvature to face" and the surface looks smoother; however, the replace face was failed . I had this problem (sometimes I had to change to NONE) few times before and still don't understand what causes the error? do you mind to give out a hint?
Thanks. Making closed groups did the trick.
Retrieving data ...