AnsweredAssumed Answered

Description column not working for drawings

Question asked by Thomas Hotchkin on Nov 3, 2016
Latest reply on Nov 6, 2016 by Thomas Hotchkin

Hey all,


Trying to fix a small issue with the PDM setup, I'm sure its something little but just can't work it out!


So the data card for the drawing files gets populated from the part data card, which is working fine now. However only the @ tab on drawings gets populated, while the columns in explorer reads the Sheet1 tab which is empty.


Is there any way I can either push the data to all the sheet tabs or make the explorer columns look at the @ tab instead?