AnsweredAssumed Answered

DWG callout doesn't capture thread with near side countersink

Question asked by Devon Berman on Oct 28, 2016
Latest reply on Nov 1, 2016 by Kevin Pymm

I'm making a part that has a tapped hole with a near side countersink to make sure the mating screw head has enough clearance.  But I can't seem to get the thread callout to show up.  I dimensioned the CS and the thru hole, but neither seems to grab the thread data.  Has anyone run into this?  In the bottom projection, the same thread works fine, but that one doesn't have the CS.  Anyone have any thoughts on this?

 

SW Thread Callout Issue.PNG

Outcomes