This isn't right. I'm pretty sure this is telling me I have to delete my model in order to turn on auto update cutlists. Please tell me I'm wrong...
This isn't right. I'm pretty sure this is telling me I have to delete my model in order to turn on auto update cutlists. Please tell me I'm wrong...
Right click on cut list and hit delete and then set the option to on.
well damn. Next question. When I go into the properties for the cut list and click the down arrow I don't get anything to select from. Hoping this is just as simple of an answer.
did u recently upgraded SW versions? if you did then have a look in there:
See if this is pointing to the current version of SW software, if not then point it to the new version file.
i did just switch versions and machines... so none of this stuff updated??? i found the right file in almost the same place as the wrong path that was in there with the exception of "2016 SP04" - "2017 SP0"
Edit: All of my file locations point to 2016 SP04 files. Could this be a copy settings wizard issue?
You updated to 2017 SP0???
PHEW! You must have quite a pair...
Thats funny! I usually upgrade immediately, help with bugs and stuff... never the EV's though. Plus I just got a BOXX APEX2 so I figured what I lose in bug time (none so far aside from this apparently, which is most likely my fault) I can gain in productivity.
If you upgraded from 2016 then SW takes the already existing locations. So better when you upgrade, check all settings/option. Set them correctly and then take a backup.
Check if this file is properly set OR not
Right click on cut list and hit delete and then set the option to on.